Fluid Measurement Section(Publication)


 



最近の主要論文

1999

 寺尾，高本，"カルマン渦流量計の渦発生体形状の最適化と不確かさの算出法に関する研究"，
計測自動制御学会論文集，Vol.35, No.5, 623/629(1999)

 Ishibashi and Takamoto, "Discharge Coefficient of Super Accurate Critical Nozzle 
at Pressurized Condition", 4th International Symposium on Fluid Flow Measurement, 
Session 6, Denver(1999) 

 Takamoto and Terao, "Standardization of Vortex Shedding Flowmeter", 4th International 
Symposium on Fluid Flow Measurement, Session 17, Denver(1999)

 Terao and Takamoto, "Uncertainty Analysis of Large Water Flow Calibration Facility", 
4th International Symposium on Fluid Flow Measurement, Session 14, Denver(1999) 

 栗原，寺尾，高本，"流速標準のためのレーザドップラ流速計校正装置の開発と不確かさ解析"， 日本機械学会論文集（Ｂ編），Vol.65, No637, 3029/3034(1999) 

 寺尾，高本，"渦発生体基部の間隙によるカルマン渦流量計の特性改善"， 計測自動制御学会論文集，Vol.35, No.12, 1628/1630(1999) 



1998

 崔 海晩，寺尾吉哉，高本正樹，松井剛一，”カルマン渦流量計内部の流れ構造に関する
実験的研究（第１報，トリプルワイヤによる流速測定）"，日本機械学会論文集（Ｂ編），
Vol. 64，No.3，649/655(1998)

 M. Ishibashi, M. Takamoto, S. Nakao, E. Watanabe, Y. Yokoi and Y. Ina, 
"Calibration of Critical Nozzles by Critical Nozzles", Proceedings of FLOMOKO'98, 
31/36, Lund, Sweden(1998)

 H. Ishikawa, M. Takamoto, K. Shimizu and G. Matsui, "Calibration of Critical 
Nozzles by Critical Nozzles", Proceedings of FLOMOKO'98, 137/142, Lund, Sweden(1998)

 Y. Terao, H. M. Choi, M. Takamoto and G. Matsui, "Measurement of Karman Vortex 
Street shed in a Circular Pipe using a Triple Hot Wire Probe", Proceedings of FLOMOKO'98, 
197/201, Lund, Sweden(1998)

 M. Hayakawa, Y Ina, Y. Yokoi, M. Takamoto and S. Nakao, "Development of the Transfer 
Standard with Sonic Venturi Nozzles for Small Mass Flow Rate of Gases", Proceedings of 
FLOMOKO'98, 303/308, Lund, Sweden(1998)

 S. Nakao, Y. Yokoi, T. Hirayama, M. Takamoto, J. Barbe and A. Marscha, "Intercomparison 
Tests of BNM-LNE with NRLM or Small Mass Flow Rates of N2, Ar and He in the Range from 
40 mg/min to 10 g/min", Proceedings of FLOMOKO'98, 517/522, Lund, Sweden(1998)

 高本正樹，石橋雅裕，中尾晨一，”気体流量の標準と音速ノズルの特性に関する研究”，
計測自動制御学会誌（総合論文），Vol.37, No.6, 432/445(1998)

 石橋、高本、中尾、横溝、"音速ノズルの直列接続による試験とその応用”
計測自動制御学会論文集、Vol.34, No.7, 698/706 (1998)

 石橋、高本、渡辺、"圧力計の直線性のみを利用した音速ノズルの高精度相対校正法”
計測自動制御学会論文集、Vol.34, No.7, 707/713 (1998)

 J. D. Wright, G. E. Mattingly, S.Nakao, Y. Yokoi and M. Takamoto, 
"International comparison of a NIST primary standard with an NRLM transfer standard 
for small mass flow rates of nitrogen gas", Metrologia, 1998, Vol. 35, 211/221.

 Ishibashi and Takamoto, "Discharge Coefficient of Critical Nozzles Machined 
by Super-Accurate Lathes", Proceedings of the 1998 NCSL Workshop and Symposium423/442 
(July 1998, Albuquerque)



1997


 寺尾吉哉，高本正樹，片桐拓朗，”風速計校正用微風速風洞の開発”，
日本機械学会論文集Ｂ編，Vol. 63, No. 607, (1997)

 Y. Terao, M. Takamoto, G. E. Mattingly, "Preliminary Intercomparison of Anemometer 
Calibration Systems at Very Low Speed between Japan and the USA", 
JSME International Journal, Ser. B, Vol.40, No.3, (1997)


1996

 M. Takamoto, "New Flow Measurement Technology for the Next Century", Proc. 
FLOMEKO'96 (1996).

 S. Nakao, Y. Yokoi and M. Takamoto, "Development of a Calibration Facility for Small Mass 
Flow Rates of Gas and the Uncertainty of a Sonic Venturi Transfer Standard", Flow 
Measurement and Instrumentation, Vol. 7, No. 2, 77/83 (1996).

 Kurihara, N.; Takamoto, M., Proc. of 8th Int. Sym. on Applications of Laser Techniques to 
Fluid Mechanics, Lisbon, pp. 34.5.1-34.5.5 (1996)


1995

 M.Takamoto, Y.Terao "Dry Calibration of a Vortex Shedding Flowmeter", 
Joint ASME/JSME Symp. on Fluids Engineering (1995)

 Y.Terao, M.Takomoto "A Very Low Speed Wind Tunnel for Anemometer Calibration", 
Joint ASME/JSME Symp. on Fluids Engineering (1995)


1994

 M.Ishibashi, M. Takamoto, N. Watanabe, Y. Nakao, "Precise calibration of critical nozzle 
of various shapes at the Re 0.8 - 2.5 x 10５", Proceedings of FLOMEKO'94, NEL, Glasgow(1994)

 M.Takamoto,Y.Terao,"Development of a standard vortex shedding flowmeter", 
Proceedings of FLOMEKO'94, NEL, Glasgow(1994)

 M.Takamoto, K. Shimizu, "Study on characteristics of an ultrasonic gas flowmeter 
for a range of small flow rates", Proceedings of FLUCOME'94, 473/478, Toulouse (1994)

 Y.Terao, M. Takamoto, et. al, "Velocity distribution in a very low speed wind tunnel", 
Proceedings of FLUCOME'94, 233/237, Toulouse (1994)


1993

 石橋、高本、渡辺、他、”定積槽方式により測定されたソニックベンチュリノズルの流出係数の
不確かさ評価”、計測自動制御学会論文集、Vol.29, No.1 (1993)

 高本、内海、渡辺、寺尾、”渦流量計の性能評価と設置条件の影響”、
計測自動制御学会誌、Vol.32,No.8 (1993)

 石橋、高本、渡辺、"ソニックベンチュリノズルの内径形状と流出係数の高精度測定"
計測自動制御学会論文集、Vol.29, No.9 (1993)

 M.Takamoto, H.Utsumi, N.Watanabe, Y.Terao, "Installation Effect on Vortex Shedding 
Flowmeters", Flow Measurement and Instrumentation, Vol.4, No.4 (1993)

 Y.Terao, M.Takamoto, et. al., "An Experimental Study on Flow Structure in Vortex 
Shedding Flowmeters", Proceedings of FLOMEKO'93, 507/514, Seoul (1993)

 M.Takamoto, M.Ishibashi, N.Watanabe, et. al.,"Intercomparison Test of Gas Flow Rate 
Standards", Proceedings of FLOMEKO'93, 75/82, Seoul (1993)


1992

 寺尾、高本、他、"市販微風速計の計測値の信頼性"、計測自動制御学会論文集、Vol.28, No.3
(1992)

 中尾、"微小質量流量の校正とトレーサビィリティ"、計量研究所報告、Vol.41, No.2 (1992)

 石橋、高本、渡辺、他、”常圧におけるソニックベンチュリノズルの高精度校正”、 
計測自動制御学会論文集、Vol.28, No.12 (1992)


    the small flowrate test facility

	



                 お終い

                 戻る

                 HOME